Free model
Print-in-place animals

Little animals that bend, wiggle and survive a six-year-old.

We make articulated animals for 3D printers. They come off the bed in one piece, we test the joints on real machines before you get them, and there's a new one every month.

Why ours print

Most flexi models fail at the joints. That's the bit we spend our time on.

  • No supports. Ever.

    Prints flat on the bed, in one piece. There's nothing to cut off, nothing to sand, and no little forest of scrap plastic to bin afterwards.

  • We print it before you do

    Every model goes through a Bambu, a Prusa and an Ender first, in PLA and in PETG. If a joint fuses on any of them it goes back to the artist.

  • A new one every month

    One new animal a month, drawn to sit alongside the ones already on your shelf. Nothing ever gets retired, so the collection only grows.

The village

Meet the villagers

See all of them
The whole village

Every villager, every month, on MyMiniFactory.

You get the new animal each month, plus the whole back catalogue from before you joined. If you print to sell, the commercial licence is in there too.

Join on MyMiniFactory

Also available on

Start your village

A full-size print-in-place dragon, already run through a Bambu, a Prusa and an Ender. No supports, no raft, and the tail still moves at the tip. About 4 hours on a stock profile.